# Crop VoronoiMesh by States Latitude and Longitude

I want to crop a VoronoiMesh output (made with some point inside a Country state) by this same state border.

I downloaded a .kmz file here. From this file, I saved the border of São Paulo state in another .kmz file. The command below is how I plotted the state border of São Paulo:

spStateForm = {Transparent, Import["SP.kmz", "Data"][[1, 2, 2]]}
Graphics[{EdgeForm[Thick], spStateForm}]


To plot the contour of this specific State.

How to proceed to crop the VoronoiMesh? And then, how to output both Images/Graphics (I don't know how to call it) to show the VoronoiMesh inside the state, without it's own default border and it's lines conecting to the borders?

What I did above is a acceptable way to begin solving this problem?

• Ignoring lack of contents of SP.kmz`, a question popped in my mind: how to compute Voronoi diagrams on a geoid, or other non-Euclidean surfaces? – kirma Oct 14 '14 at 12:13