Take the 2-minute tour ×
Mathematica Stack Exchange is a question and answer site for users of Mathematica. It's 100% free, no registration required.

I have a LabJack U3-HV and I wanted to use it with Mathematica to interface some hardware. I cannot find any information on the Internet; if I have to use Python, I will, but I would rather use Mathematica. Does anyone have any advice on this?

Specifically, I can't figure out how to read "AIN0" (the LabJack's first analog input) using Mathematica.

share|improve this question
    
Nice idea. I think you'll have to write the interface to the device yourself using the provided C/.NET/Java libraries and either LibraryLink, NETLink, or JLink as appropriate. A lot of information is provided here. –  Oleksandr R. Jun 24 '13 at 19:09
    
Perhaps this link may give you some insight into grabbing serial port data. –  bobthechemist Jun 25 '13 at 1:59
    
FWIW, the LabJack is not a serial port device; one must link with its own library to get access to its inputs and outputs. I haven't got one to try it myself, but the procedure for getting it working in Mathematica will be pretty much the same as shown for IGOR or MATLAB in the link I posted above. I think there is more than enough information there to get it going. –  Oleksandr R. Jun 25 '13 at 12:23
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.